Step 1. Towel-dry your hair until it is damp. Slide the power switch up and select the desired settings. The red light indicates “ON.” Use the Pre-Styling Dryer attachment to dry the roots and remove excess water. Cool – cool setting, low power consumption. Low – high heat, low power. Hot – high heat, high power. Styling tip: Always prep your hair with a heat protectant whenever you apply heat to your hair. For extra volume and control, use a styling mousse or root-lifting spray.
Step 2. Section your hair into 2-inch sections using our Grip Clips. Use the 60-mm attachment to start with the lower sections. Place the oval 60-mm brush near the roots and brush slowly away from the head. Continue doing this to remove moisture and dry each lower section. For extra bounce, wrap the ends of your hair around the barrel to achieve a bouncy blowout look.
Step 3. To get more defined curls, switch to the 32-mm attachment. Wrap the hair around the barrel while simultaneously pulling the tool downward and twisting it. This gives you the curl and bounce you’d normally only get at a salon.
Step 4. When you’re done drying your hair, slide the button down to “OFF.” Set your blowout with hairspray for extra hold.
Let the interchangeable blow-dry brush cool completely before removing the heads and storing them.
Tip: Revive two-day-old hair with a little dry shampoo and a blowout at the roots! Always use a safety stand with all heat styling tools.
All heat styling tools should only be placed on heat-resistant surfaces.
Allow all heat styling tools to cool down before storing them.
Heated appliances should only be placed on heat-resistant surfaces.